@#% balancer pulley
Did my cam swap this weekend but the balancer install tool I rented wont reach the threads that far back in the crank and looked all over for a bolt or some allthread to make a tool but couldn't find anything that long in 16mmx2.0.
What do I need to do here?
2009 MSM GT
Roto-fab, OBX, Solo, VMS 1.5 cam, Brembo's, Staggered VMR 710, Eibachs, BMR Sways, TVS2300, AIS meth injection, and RCR tuned
Oops....wrong section. I will repost in the L76
2009 MSM GT
Roto-fab, OBX, Solo, VMS 1.5 cam, Brembo's, Staggered VMR 710, Eibachs, BMR Sways, TVS2300, AIS meth injection, and RCR tuned
I can sell you one I made from allthread, some washers and a piece of pipe.
$30 shipped.
heat it up with a torche just the inner circle on the pullley make sure its off from the crank. heat EVENLY in a round motion for 2minutes and slide it into place with your own two hands. put the bolt back on with some red locktite and your done.
I have G8GT 888 Last In 08...
Front/Rear Camaro Brembo Swap/ Drilled-slotted Rotors, EBC Yellow pads
FE3 Suspension, BMR Sway Bars, BremmerKraft Wheels,
Eibach Springs.
Magnaflow 3" catback With 3''high flow cats.
Rotofab CAI
Radical Ported TB/ Intake manifold from Peak Speed Shop
VectorMotorsports Tune
Red Bulbs all around
PLasti dip Vynil wrap handles, roof, spoiler, hood
HID Kitsui 6000k
DougTHorley LT headers
Powerband Pulley
ReckArt Ls3 MAF Sensor/Housing
Red Aircraft Aluminum Paddle Shifters
Red/black GXP steerng wheel....
Posting Permissions
Reply With Quote