Tweaking with HPTuners

[PerfectD3]

You've done alot of changes, I'll have to look over it more in detail tonight. I hope you don't mind questions, I'm still trying to learn everything I can. I think I may use your rpm vs torque though, seems smarter than my 6042 across the entire range.

[PerfectD3]

Hey that's not too bad. I'm going to scale my normal pattern back to somewhat stock for driveability~longevity's sake. I also got a good log for my maf calibration now and am going to work on it some.

[G8-4-Speed]

Hey that's not too bad. I'm going to scale my normal pattern back to somewhat stock for driveability~longevity's sake. I also got a good log for my maf calibration now and am going to work on it some.

Thanks, it is a lot work to do it all so I did some "group" changes since I was so irritated with stock shifting.
I just re-looked at my setting and adjusted my normal vs A Pattern. Just a slight change.....since it was a little bias toward the normal. I changed all my shift points also since it was subburn about down-shifting. My shift points in "A Pattern" currently give me 6100-6200 shifts.

[PerfectD3]

Yeah I noticed a 2-3 flare though. Any idea on how to get rid of it?

[GRRRR8]

HPT question. When you are doing a histogram and all the boxes have colors in them and numbers, then there are some that dont. I am lost. I searched HPs website..nothing that talks about it specifically, looked it 3 different books, and I know that this is how you are calculating, but I have clicked every help and cant get a clear understanding. I cant be that busy or stupid so what gives?

[PerfectD3]

Charlie,
If you are talking about boxes that remain white without any values, then that just means there wasn't any information for that spot collected. Either you didn't hit it (chasing kPa and MAF hertz is a bitch) or your minimum cell count for your histogram is too high.

[GRRRR8]

Charlie,
If you are talking about boxes that remain white without any values, then that just means there wasn't any information for that spot collected. Either you didn't hit it (chasing kPa and MAF hertz is a bitch) or your minimum cell count for your histogram is too high.

The white boxes that a # pops up in. The blanks I understand, its the white boxes when a # shows up that I am trying to figure out. Do you know any good articles I can read about this?

[PerfectD3]

Can you post up a screenshot? White with numbers may mean the middle ground for when you setup your histo. ie. 0 as your min 50 as your high, 25 (and around there) will show up in white.

[GRRRR8]

I didnt save it since it didnt make any sense.

[PerfectD3]

You remember what the number in white was? Double check your histo config it may have fallen into the middle that I was talking about in my last post.