Anyone near Anderson SC?

**wreckwriter** · 12-30-2008, 07:56 AM

Rick, see the last picture at this link:

http://www.bmrfabrication.com/INSTAL...13_install.pdf

This is why I'm asking. I have these parts on my car and want to know if your loop will conflict.

**wreckwriter** · 12-30-2008, 07:57 AM

Originally Posted by Rick@Metco

As of now, we are only working on a front loop.
The loop is two pieces (mount & hoop), and the installation of the mount requires the opening of two holes in the crossmember to accomodate the 7/16" bolts. The holes are pre-existing, but they are partially blocked from the factory and must be enlarged slightly.
We may pursue the development of a rear loop at some point in the future.

Oh, ok, I was under the impression you were making front and rear loops.

**Rick@Metco** · 12-30-2008, 08:05 AM

Originally Posted by wreckwriter

..I have these parts on my car and want to know if your loop will conflict.

Nice parts...
There should be no interference with our loop.

**wreckwriter** · 12-30-2008, 08:07 AM

Originally Posted by Rick@Metco

Nice parts...
There should be no interference with our loop.

OK, let's get it done then

**TheTugBoat** · 12-30-2008, 08:13 AM

whats a loop?

**wreckwriter** · 12-30-2008, 08:14 AM

Driveshaft safety loop. Keeps shaft from contacting the ground and pole-vaulting your car if the shaft breaks at the front.

and yes, a car will polevault straight onto its roof in some circumstances, I've seen it done.

**Chewy** · 12-30-2008, 08:55 AM

Originally Posted by wreckwriter

Driveshaft safety loop. Keeps shaft from contacting the ground and pole-vaulting your car if the shaft breaks at the front.

and yes, a car will polevault straight onto its roof in some circumstances, I've seen it done.

http://www.youtube.com/watch?v=Uzpbz5aLJms

**wreckwriter** · 12-30-2008, 09:00 AM

I saw a Ford go straight over onto the roof at the strip when I was a kid.

Thread: Anyone near Anderson SC?

Thread Tools

Posting Permissions