Dyno pulls

[Art708]

I went this morning and had my stock G8 dynoed so I'd know what it runs stock. The 3 pulls were:

HP TQ

297.88 315.33
297.01 316.73
299.56 322.97

Is this about normal for a stock G8.....1200 miles on it?

I'm getting a price for Roto-Fab, Magnaflow cat backs, UDP, 160 thermostat.

BTW, my DashHawk came today. Now I just gotta figure out what to do with it besides look at it. :)

[GRRRR8]

Thats the norm. 290-300

[MissNaySimon]

Hm. Not bad. Now I have some rough estimates to give to people when they ask.

[Art708]

How does $1960 sound for Magnaflow cat backs, Roto-fab CAI, UDP, new belts, 180 t-stat, dyno tune, and labor?

[-Ray-]

Your numbers are very close to what I had stock.

[Art708]

Your numbers are very close to what I had stock.

I think that's about where most of them will run. I hope that I get some good number after all the mods.

[-Ray-]

I'm sure you will, this engine responds very well to mods.

[GRRRR8]

That is a GRRRR8 price! PM Sent

[G8GTlawride]

I went this morning and had my stock G8 dynoed so I'd know what it runs stock. The 3 pulls were:

HP TQ

297.88 315.33
297.01 316.73
299.56 322.97

Is this about normal for a stock G8.....1200 miles on it?

I'm getting a price for Roto-Fab, Magnaflow cat backs, UDP, 160 thermostat.

BTW, my DashHawk came today. Now I just gotta figure out what to do with it besides look at it. :)

Just plug it in the OBDII port and start the car, thats it. You can then set your custom screens the way you want.