View Full Version : Catch Can Installed on GXP
MoonPie
04-08-2009, 04:18 PM
Put it on today, wasn't too much trouble. I do have some pics which would go well with the tutorial provided by BP on their site if anyone needs them.
kje141
04-08-2009, 04:31 PM
You have a hard time getting the stock air box back on? When I did mine I couldn't quite get the snorkel to go all the way back on and line that hex nut on the bottom inside of the air box (filter removed). Ended up saying forget it and just tightened the other two nuts that hold down the air box.
MoonPie
04-08-2009, 07:51 PM
All I had were the two nuts holding the airbox to two red anchor screws, nothing on the inside of the airbox except a hole in the bottom with something sticking through it, not sure what it is. Didn't have a hex nut on the bottom inside of airbox.
You have a hard time getting the stock air box back on? When I did mine I couldn't quite get the snorkel to go all the way back on and line that hex nut on the bottom inside of the air box (filter removed). Ended up saying forget it and just tightened the other two nuts that hold down the air box.
Mozilla/4.0 (compatible; MSIE 6.0; Windows NT 5.0) BlackBerry8310/4.2.2 Profile/MIDP-2.0 Configuration/CLDC-1.1 VendorID/102
kje141
04-09-2009, 05:11 AM
On my GT that hole at the bottom with something sticking through it could be taken off. I used a alan wrench but I really needed a torx wrench. It appeared to be a third point on the air box to hold it down. Couldnt get that bolt back in with the catch can on the upper anchor screw, it threw all the alignment off.
MoonPie
04-09-2009, 06:25 AM
I had the same problem, ended up just mounting the can on top of the box, no problems so far, used the original nut and locking washer, didn't use the nut that came with the catch can. I was able to get the alignment back to normal. There is also a peice of plastic that helps anchor the snorkel to the front of the car, if you can feel around to make sure its in the slot on the snorkel you should be fine, then just tighten everything up.
cowbiker
04-18-2009, 12:51 PM
I just bagged the O.E. intake at the same time, along with the Heater Hose kit.
http://farm4.static.flickr.com/3634/3434270261_8c0c31a8dd_b.jpg
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.