View Full Version : OK, what did I do now?
GXPaycheck
03-26-2009, 01:42 PM
Took off the RotoFab for cleaning, and while it was off I removed the TB to rearrange the vac lines a bit. Everything went back together fine with no codes, but now I can't get the engine over 4000 rpms. Rechecked connections, sprayed some MAF cleaner on the MAF, and swapped ECM's but the problem remains.
Any ideas?:notworking:
-Ray-
03-26-2009, 01:47 PM
You mean while driving correct?
GRRRR8
03-26-2009, 01:48 PM
Unplug the throttle body and plug it back in. You have a bad connection and it is in "limp" mode. It should be setting a code shortly. Make sure your MAF and all hose connection are good and that you hooked up the little hose to the valve cover.
GRRRR8
03-26-2009, 01:56 PM
You mean while driving correct?
Good point as it wont rev past that in park.
GXPaycheck
03-26-2009, 03:15 PM
4000 in park or driving. On the road at 4k it just bogs down and bucks.
GXPaycheck
03-26-2009, 03:33 PM
FIXED!!
Reset the plug on the TB and re-booted the car for good measure. Now I can get sideways again!
Thanks for the help, Charlie! Next time I won't just push on a plug to make sure it's secure. Gotta pull it and reset it.
Now to go get junior at karate and see if he's still in one piece!
:theman::theman::theman:
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.