View Full Version : Inst mpg reading
TurboSS
03-21-2009, 06:32 PM
I read on another board that the gxp's show gal/hr when stopped but change and show mpg when moving... Have u gxp guys seen this? Anyone know if us little GT guys might be able to get this added on.
Blackrider
03-21-2009, 07:13 PM
I read on another board that the gxp's show gal/hr when stopped but change and show mpg when moving... Have u gxp guys seen this? Anyone know if us little GT guys might be able to get this added on.
Its in Engineering mode.
TurboSS
03-22-2009, 05:06 AM
[QUOTE=Blackrider;63019]Its in Engineering mode.
I know it's in eng. Mode but it displays it in gal per hour. I was saying I read on another board that the gxp's once moving theirs switch and display miles per gal
caretaker
03-23-2009, 04:45 AM
I doubt you can get a factory add-on. Probably would require a
software / firmware upgrade.
I have my DashDyno set to 4 meter mode with it displaying
Gal/Hr, Inst. M.P.G., Average M.P.G., and IAT all the time.
Also I have checked and the average M.P.G. is more accurate
from the DashDyno than the factory one because it samples more often.
I would imagine that a DashHawk, which a lot of the guys here use,
could do the same thing.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.