DIY: Differential Mount Bushing Replacement

[Jaysin]

Here is my garage floor install of Pedders differential mount bushings. Any feedback you want to provide is appreciated.

http://g8modz.com/differential.htm

[GeorgeInNePa]

Very nice write up.

I got 3 sets of bushings marked "A", I didn't get any B. Was B just a bit thicker/deeper? The center sleeve seemed a bit short in the rear mount.

[Jaysin]

Very nice write up.

I got 3 sets of bushings marked "A", I didn't get any B. Was B just a bit thicker/deeper? The center sleeve seemed a bit short in the rear mount.

Thanks.

The metal sleeves are all the same. 9167B's are a tad smaller I believe. You might want to as Mike (DMS) if it matters or not. Also, make sure you look at all halves. Mine arrived with A's and B's on the same sleeves. They were assembled A-A, A-B, and A-B.

[13 QTR]

Gotta admit...^that's a damn good write up. I feel like going back and deleting my old write up....or maybe insert yours in there. Of course mine wasn't in the car at the time.
I still don't remember there being a A & B on any of them. They were all in the same bag..so I don't know what's on them. It all went in good..and I'm not going to take it back out to find out.

[99-LS1-SS]

Here is my garage floor install of Pedders differential mount bushings. Any feedback you want to provide is appreciated.

http://www.stlg8s.com/tutorials/differential/index.htm

Thank you very much for this write up! This will help me greatly!