PDA

View Full Version : Windshield washer fluid lines/tubes



DJ_57
06-02-2015, 01:34 PM
The windshield washer fluid lines, there is a soft rubber hose from the pump to right near the right strut tower, from there it has a fitting that slips onto a hard shitty brittle plastic line (approx 1/8" diameter, very small) that runs along the top of the engine compartment under the cowl pieces, it connects to a tee and feeds the two squirters where they are mounted onto the actual cowl piece.
I broke the end of the hard shitty brittle plastic line and while working with it to replace it (got it replaced up under the cowl with a bit longer rubber hose), cracked it elsewhere when it got pinched between layers of the cowl.
Is any of it replaceable/available?

The usual GM parts sites show it on the illustrations but no p/n listed.
Item #6 below, contains this line, plus the tee that is immediately underneath the RH squirter location on the cowl, and more hard shitty brittle plastic line to go to the next squirter
http://www.tonkinonlineparts.com/images/parts/gm/fullsize/071114HE10A505.JPG

Does this separate from the tee, if anyone has been through this before?

I've tried removing more of the line but the cowling in the way, and the clips won't give, and I can't find those available anywhere either. I'm sure they're made of the same hard shitty brittle plastic :)

Crazy Paul
06-02-2015, 02:34 PM
Item 6 = 92185187
http://parts.nalleygmc.com/showAssembly.aspx?ukey_product=3129901&ukey_assembly=378157

DJ_57
06-02-2015, 02:42 PM
Dang, you're good...must have looked it up a different way because I couldn't see it whether I looked for a G8, Caprice, or a new SS...


Does anyone know how it separates from the two fittings on the top side of the cowl?