PDA

View Full Version : Launch question


SuperSonic
02-24-2009, 08:54 PM
On my 13.4 run I launched at about 800 revs now that doesnt seem like allot to me now if I launched at say 1300 does anybody think my time will go down is it possible to get down stock to say a 13.2??
bwooten492
02-24-2009, 08:59 PM
What was your 60ft time?
GRRRR8
02-24-2009, 08:59 PM
It will all depend on wheel spin. I would think a minimum of .1 with a higher launch RPM if the wheel spin remained the same as your 13.40.
SuperSonic
02-24-2009, 10:31 PM
Well there was minimal to no wheel spin and I have a set of dr's but i dunno if that would help.
SuperSonic
02-24-2009, 10:32 PM
60 ft was 2.05
bwooten492
02-24-2009, 10:35 PM
Put the DR's on and stall it up until it starts creeping. It should be worth something.
SuperSonic
02-24-2009, 11:04 PM
Then I cant use the word stock anymore and thats no fun muwahahaha.
SuperSonic
02-24-2009, 11:04 PM
Has anyone every started spinning at the line??? Is that a common occurance because thats probably whats going to happen.
SuperSonic
02-24-2009, 11:12 PM
Not spinning after launch but like during preload.
GRRRR8
02-25-2009, 05:15 AM
Yes. I would put the DRs on as it would still be stock and try launching at the highest the brakes will allow.
blackbirdws6
02-25-2009, 06:32 AM
Launch as high as you can without spinning badly. I think my 60' was right around yours when I left a little above idle. I increased it a few hundred rpms and the car left solidly to a 1.96 60'. Play around with it a bit.