PDA

View Full Version : What are the lengths of our stock wheel studs?


desertg8
02-28-2011, 06:37 PM
I am a little tired tonight from preparing a bunch of returns. I am a cpa. I did not want to pull my wheel tonight to measure it. Just the length from where it protrudes from the hub or whatever you call it. Is it one inch, one and a quarter, or one and a half? I need that info. for adapters.
G8GTKID
02-28-2011, 07:33 PM
I want to say they are 14mm x 1.5mm...

Sent from my DROIDX using Tapatalk
G8GTKID
02-28-2011, 09:02 PM
I want to say they are 14mm x 1.5mm...

Sent from my DROIDX using Tapatalk

This ^^^ is confirmed. 14mm x 1.5 mm studs.

Sent from my DROIDX using Tapatalk
Crazy Paul
02-28-2011, 09:12 PM
14 x 1.5 is the thread size and pitch, nothing to do with length.

Here:


Stock G8 wheel stud 92171058.

http://i2.photobucket.com/albums/y20/PerthPurplePenguin/car%20parts/R1010717.jpg

Thread size M14 x 1.5
Length underhead to first usable thread 45mm
Length underhead to extremity 58mm
Knurl diameter 15.70mm
Shoulder length 13.40mm

From the chart below S6120 is a match, except length which is 73mm.

http://i2.photobucket.com/albums/y20/PerthPurplePenguin/car%20parts/WheelStud_Web_0407_Page_80.jpg
G8GTKID
03-01-2011, 04:23 AM
Hmm got that off the G8 board...?

Sent from my DROIDX using Tapatalk
desertg8
03-02-2011, 04:30 PM
Holden Parts Supplier,

What are the lengths of your enlongated studs? 1/2 inch over stock, 1 inch over stock???

What is the cost of ten of them sent to Tucson, AZ with the corresponding nuts? Or can I use the original nuts?

I have a feeling I will not be able to use my pontiac black caps.

Thanks
Crazy Paul
03-03-2011, 05:26 PM
What are the lengths of your enlongated studs? 1/2 inch over stock, 1 inch over stock???
S6120=73mm
Stock =58mm
Therefore S6120 is 15mm longer than stock.



What is the cost of ten of them sent to Tucson, AZ with the corresponding nuts? Or can I use the original nuts?
Currently US$160 shipped by Airfreight.
It's stock thread size and pitch so you re-use stock nuts.


I have a feeling I will not be able to use my pontiac black caps.
Depending on how thick your spacers are, you'll be able to use stock black caps....unless you use thin spacers which makes too much thread poke out the end of the nut.