View Full Version : How to check ignition wires ?
LS3_UAE
06-09-2010, 12:39 AM
I wanted to know whats the best way into checking the ignition wires if they are working properly or not.
and what about the Coils as well ?
There is a misfire on an LS2 engine but the hp tuners just says engine misfire detected so I dont really know on which CYL#
Thanks.
-Ray-
06-09-2010, 04:55 AM
You need an ohm meter to check the wires. I don't have the specs with me, but I think someone here should. Move the wires around while you check.
GRRRR8
06-09-2010, 07:43 AM
You can have lean misfires that dont identify the cylinder. Checking wires: Ohms should be around 200-300 MAX. MSDs and other aftermarket wires will be around 50 ohms.
Rayvan
06-09-2010, 09:44 AM
Move the coil/wire assembly to another cylinder. See if the problem follows the assembly.
norm8332
06-09-2010, 10:05 AM
Vacuum leak?
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.