View Full Version : anyone in seattle area get the new control arms yet?
grandmacpubah
11-11-2009, 04:59 PM
Just wondering if anyone has gone to get the new control arms yet. My VIN is in the range and I can't tell if I have loose feeling steering or if its in my head. I haven't been motivated enough yet to see if I can get the dealership to do anything based on my vin being in range.
08G8V8
11-11-2009, 05:52 PM
no, but it sounds like they want us to get it taken care of:
http://www.forum.grrrr8.net/showthread.php?t=12286
grandmacpubah
11-11-2009, 05:54 PM
no, but it sounds like they want us to get it taken care of:
http://www.forum.grrrr8.net/showthread.php?t=12286
are you in the VIN range too?
08G8V8
11-11-2009, 06:01 PM
looks like it.
r33pwrd
11-11-2009, 06:31 PM
mine goes in on Friday for a rear suspension clank... they looked and said there is no recal on control arms for my car.
Executor999
11-11-2009, 06:36 PM
Don't know if I'm in the VIN range yet, but I had Justin at Norpac look at my balljoints and they are good to go. Didn't think about the control arms; will have to get them checked next time.
08G8V8
11-11-2009, 06:41 PM
I'm sure this is posted somewhere on here, but rather than searching for it, here's a link:
http://www.g8board.com/forums/showpost.php?p=358617&postcount=7
sweetair
11-11-2009, 08:03 PM
What is the VIN range? Where can this info be located? Thank you.
What is the VIN range? Where can this info be located? Thank you.
The VIN range is in the G8Board link right above your post.
08G8V8
11-12-2009, 08:52 AM
Got Revord ordering the kit for me. I figured I might as well get it done.
Want to get it done before my Pedders gets installed, so they don't try and blame any issues on that. But, I doubt I will have any issue getting it done before then, as my Pedders parts were ordered in LATE AUGUST so I probably have at least a few more months before they show up!
grandmacpubah
11-12-2009, 08:22 PM
are they ordering the boots or the control arms?
08G8V8
11-12-2009, 08:32 PM
are they ordering the boots or the control arms?
I guess I'm not sure. I haven't really read it over that closely. Are there (2) seperate TSBs?
I see a #09-03-08-008 from this thread:
http://www.g8board.com/forums/showthread.php?t=24446
Then I see the #09203A from the thread I linked to earlier.
Are they not the same?
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.