Breyton Race CS

[svtcobra]

Do you think these wheels ( Breyton Race CS, Matte grey w/red stripe) will look good on a Black or Gray G8. You can see them at Tire Rack.com.
http://www.tirerack.com/wheels/WheelCloseUpServlet?target=wheelCloseUp&wheelMake=Breyton&wheelModel=Race+CS&wheelFinish=Matte+Grey+w%2FRed+Stripe
Thanks

[-Ray-]

I've seen 'em on another board. They do look good with that color. I don't know about that red stripe though.

[Chewy]

I've seen 'em on another board. They do look good with that color. I don't know about that red stripe though.

Diddo! Love the wheel, but hate the stripe.

[95_9C1]

i love the red stripe

http://stickandballguy.com/blog/wp-content/uploads/2007/05/red_stripe.jpg

i love this red stripe, too

http://www.tirerackespanol.com/images/wheels/breyton/swap/breyton_racecs_mg_ci3_l.jpg

seems a classy match w/White Hot, esp. complimenting an onyx/red int

http://i550.photobucket.com/albums/ii440/95_9C1/g8_breyton_small.jpg

[Schinbone]

lol, love both strips.....Ok, mainly the one with the beer in it.

[EcoBrick Bob]

Have a set of staggered Breyton Race CS in silver with machined lip on order. Going on Spt. Red. Red stripe wheels are a matter of personal preference. MGM or Black car would show them off best.

[PantherGTBlack]

Watch out on your offsets, I had rubbing with a 9.5" with a +35mm offset.

[EcoBrick Bob]

YOU ARE BRING UP A VERY IMPORTANT POINT!

I'm aware of width issues. Have staggered Beyern Multi's with 45 offset 9.5 wheels with 050-A Bridgestone 285's that have a cross-section of almost 12 inches on my white 08'.. TireRack says staggered Breyton's will fit with no rubbing. Guess we'll see.

Another rubbing issue I have is with "Charlie's" lower panel mod. I have flap hanging down to direct air upwards. Rubs at every drive/ speed bump etc... just like my old C5 Vette! First thought it was tire rubbing!!!

[PantherGTBlack]

YOU ARE BRING UP A VERY IMPORTANT POINT!

I'm aware of width issues. Have staggered Beyern Multi's with 45 offset 9.5 wheels with 050-A Bridgestone 285's that have a cross-section of almost 12 inches on my white 08'.. TireRack says staggered Breyton's will fit with no rubbing. Guess we'll see.



These were my first set of aftermarket wheels (Breyton Race CS), and I had rubbing on the rears even with a 255/40 on the rear (19x9.5 w/ +35mm offset)! Damnit, I really like those wheels too. They were the silver, with machined lip.

[PantherGTBlack]

I imagine rolling the fenders would take care of it but I wanted to keep from that if at all possible. The rubbing was very slight to say the least, but it still rubbed.

[EcoBrick Bob]

G8V8 cut off a bit of his fenders. May have to roll them or trim them if necessary.. Just not wanting to do it to 2 cars... Unfortunately, my front air intake flap rubs all the time so will truly be dazed and confused.....