View Full Version : Power Adders
- what 58.7lbs of aluminum looks like...
- This can't be right...
- Don't sleep on Magnacharger.........
- What stock parts do i need to remove TVS1900
- Tvs with press on pulleys can get cogged too!
- Injector tick
- RX Monster catch can review
- help fuel injector probLeM
- RX catch can operation question
- Little quieter lol
- Maggie oil leak fixed
- Fuel Pressure from Maggie Fuel Rail?
- MaxPower TT G8 - Going under knife this weekend
- Anyone in SE Texas want to help with a Procharger install?
- STS is up for the task!
- School me on Fuel
- Need help from anyone with a Turbo setup.
- Porting the Blower
- Magnuson vs Procharger: Your Opinions Please.
- HOW TO: Make a Timing Retard Box for a Nitrous Oxide system...
- Maggie boost gauge sensor...
- What are the major differences between these TVS's
- anyone with a maggie running a dual pass or a icebox
- Nice set of twins at my office today
- How much boost can a 6l handle?
- Questions?? Need help on ProCharger!
- MPG with a 2300
- Money Shot!
- Our last real problem: Procharger's intake filter location
- Anyone running the twin fuel pump setup from LPE
- Cog Questions
- Interesting Offer
- Maggie and Vararam.....
- Magnacharger TVS bearing went bad. SCC & Jessika A+
- cynic783's maggie TVS1900 install thread!!!
- Anecdotal guesses wanted - does this sound like a cam??
- Coolant capacity of Maggie System?
- Kenne Bell
- Magnuson supercharger rattle
- Maggie 1900 smallest pully size with stock injectors
- LT1 procharger D1sc on g8
- Caption this picture
- ProCharger top pulley change
- Magnuson 1900 Project- over-drive Cog, Porting, & Cutting out restrictions....
- Pure sex
- New pulley gives minimal gain
- Procharger D1 and Kooks full exhaust
- Look what was delivered today!!!
- OD Cog Drive Installed
- 2 core to 3 core upgrade - new tune needed?
- Is nitrous for me?
- GXP TT 8.5psi, Squash twin 340s, & meth
- Lets talk about meth...
- My Impressions of the OD Cog Drive
- Anybody do a 102 TB with a maggie?
- Used Nitrous Kit
- Is this our newest option?
- Where to get this maggie pulley?
- Procharger kits now available at juiced motorsports - amazing deals!!!!
- Maggie 1900 Air Inlet Size?
- Maggie install w/ out removing front fascia
- 2300 Maggie: Boost a Pump or new Fuel Pump
- SLP Underdrive pulley
- CTS-V fuel pump in GT/G8
- PowerFab Automotive: Pontiac G8 GT Twin Turbo 6266 Build Thread
- 12 lbs of boost after cog drive
- Meth nozzle sizes? explain your setup here.. Alkyl system...
- Oil Inside Maggie "Without" Catch Can
- Christmas In September!
- Maggie and Snow
- fuel pumps?
- Supercharger fuel rail remove..help
- Slp tvs1900 and tvs2300 supercharger kits available at juiced motorsports!!!!
- Waste Gate for Prochargers
- maggie fuel rail removal question
- Odd whining..
- got my cogged Maggie 2300 installed and tuned----- very happy
- Procharger pulley options
- Re-calibrate DIC for actual MPG after upgrades?
- New numbers after the Maggie install
- Need Fuel System Advice
- Post install of 2.3L SC and CTS-v Pump
- Nitrous wiring progressive.
- Help Needed Diagnosing Erratic Engine Idle & Stumbling
- Should I keep pushing the maggie?
- Chrome Maggie and heat
- Nitrous inconsistencies- what to check?
- Custom Nitrous Switch Panel from Nitrous Outlet!!!
- Maggie 1900 IAT internal wire failure..
- Recommend me a torque converter
- TVS 1900 intake port
- Affordable Fuel Pump Upgrade -- if it is possible
- Nitrous
- Procharger now bad!!! yahoo!!!!
- AI Super Chiller complete for g8!
- Fuel pump access cover
- Honeywell turbo
- Return Fuel System on Magnacharger
- A couple questions for those running nos on a dd...
- Pro charger
- Maggie Install Questions
- Oil recommendations with forced induction
- New Updraft Maggie
- Direct Port Meth with Maggie
- DOD delete "with" Maggie (the correct valley cover)
- Powerdyne supercharger
- Cog drive belt part number
- What kinda numbers to expect?
- My GXP is about to get a whole lot faster...
- New blown G8
- F1-D Supporting Gear
- Update on the OD Cog Drive.
- Who is Jessika? Is she Wicked Mom?
- Question for TVS2300 owners only, please answer poll
- Twin Turbo build
- Nitrous coming to a g8 near me :-)
- Define "keeping up" as it relates to fuel pumps
- What makes the OD cog set whistle so loudly?
- edelbrock
- LDM's Magnacharger TVS1900 Install
- Recent TVS2300 Purchase
- 1900 with NW102
- OK, The Official "Who's been blown by Jessika and how was/is it?" thread.
- Magnuson Heartbeat testing in Australia
- Any Single Turbo Builds?
- Tranny Cooler with Maggie Heat Exchanger?
- What size supercharger for cammed 6 liter engine?
- Magnuson Help
- Re-enlistment time coming up....decisions
- Changing Rear Pulley from 1:1 to OD on mp1900?
- 1500 hp G8 in the making
- MSD coil packs
- Stand alone fuel cell
- Shoehorning a NW 102 TB on a 1900
- Something odd I just noticed about the OD Cog...sound.
- Magnuson 2300
- How does the Rev Extreme Monster Catch Can get installed with a Maggie?
- Nitrous Outlet Switch Panel
- LPE/ADM 417 Maggie GXP
- Fuel system installed, New numbers
- Anyone using Magnuson valley cover?
- lsa supercharger
- Maggie 2300 a BEAST
- Patrick G Tune Last night
- Building a New Motor for Buyer
- Duttweiler and Delano Maggie Inlet cover (prototype) = 127 hp over stock inlet
- 510 Race Engineering Procharger special
- Jegs 516252 under drive pulley
- 510 Race Engineering Procharged G8
- 408 Stroker and TVS2300
- AI Super Chiller Install
- lil nitrous
- pulley swap / serpentine belt change?
- Upgraded heat exchanger for supercharger
- 4th of July Special! MAGNUSON SUPERCHARGERS TVS 1900 AND 2300
- water injection
- Maggie Heartbeat
- Vector single turbo re-imagined.
- Jessika, is this your old G8?
- nitrous wire for tps signal...need help
- Supercharger PARTS
- nitrous bogging down
- Conversion to 8-rib serpentine system
- Just got my VE SS Commodore Wagon tuned........
- Pro charger crankcase pressure
- LSA retrofit pulley injector sizing
- D1SC procharged G8 MAF maxxed out
- Procharger cog setup?.... anyone yet?...
- Spark Plugs & Boost
- Part number for 60mm idler?
- need help for standalone build
- Drop in replacement fuel pump for G8/VE Commodore
- ZL1 Supercharger on a GXP
- Another Dumb Maggie v Procharger Thread
- Nitrous installed or is it? :)
- tuner or full kit
- ZL1 Fuel Pump (the correct one?)
- Can a ProCharger be my first mod?
- Update
- Need boost controller/wastegate advice... for supercharger
- Procharger I-1?
- Too Many Miles for FI?
- 1900 or 2300?
- More Power
- Boost on a twin screw roots supercharger.
- standalone fuel lines
- Maggie 2300 making weird grinding noise
- Spark Plugs
- ITBFST is getting twins
- Programmer's
- Maggie with rx dual check vavle catch can?
- Engine upgrade under way! Stock L76 has had enough!
- Magnuson Jackshaft Bearing Replacement
- NOS mini progressive controller
- Mounting fuel pressure regulator?
- Looking to give Nitrous a shot, but have some questions...
- need help wiring up standalone
- Pre cam goody questions
- cant control fuel pressure with regulator
- Size/part number belt for D1
- EBAY F1d
- ProCharger with mesh screen instead of filter?
- TSP Forged LS3-Procharger D1-Rick Crawford Cam+Tune
- Maggie TVS1900
- Install new fuel rails with Squash Fuel System ?
- What???! Big Betty is evolving... into White Lighting!!
- Calling all Twin Turbo Owners!
- Gen f gts
- So I got this ProCharger velocity stack....
- build plans from a new guy
- Rebuild complete, making 10 psi on the turbo then an engine fire. Photo update
- Cylinder head inquiry: Head Bolts vs. Head Studs
- zl1 s/c, custom ice box, cms stage 3 boost cam build
- Looking for advice from the experts
- Daily driving with cogs
- Anyone have a connection at snow performance?
- Adjusting Maggie bypass valve
- Fuel rail clearance with OD cogs?
- Magnacharger systems on sale now at juiced motorsports
- TT Intercooler options?
- 102TB snout for TVS
- Whipple
- G8 OE Fuel Level Sensor mod's for use with CTS-V module.
- So I want to mod, and have some ideas...
- Can I use ctsv fuel pump float and sender
- 2300 and E85
- Anyone heard of this Voltage Booster? JMS PowerMax
- Edelbrock 15400 E-Force Universal Supercharger Kit
- new to group need help on engine build
- cog question..
- Blower cam comparo july'14 carcraft
- Custom Twin turbo build
- Starting new upgrade: 419 LsX build
- p0174 vacuum leak
- My new TT setup
- Procharger build
- My build of My single PT88 under hood turbo.
- Turbo for 403 LQ9
- help check a lsa blower
- Procharger install with ati balancer. Spacer info needed.
- Those with turbos, which oil pump?
- How much boost on stock short block?
- LSA blower swap complete :)
- LSA Blower Install (complete parts & install tips)
- IAT relocating?
- Are you looking for a cheaper fuel controller alternative?
- Procharged BOV
- Heat shield material
- LSA Problems..Full of Oil
- Meth injection
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.