View Full Version : V8 L76/LS3
Pages :
1
2
3
4
5
6
7
8
[
9]
10
- PatG Cam Experience With Dyno Numbers (long read)
- OEM spark plug wires set part#
- ls3 dressup
- any one know ?
- Heater hose relocation question
- tune out DOD
- Should i use a forged crank for this build? Lunati lifter failure....
- Another DOD failure, oil pump relief Service Bulletin
- cam install for the dummy question
- Red X, flatlined coolant temp, AC turned itself off
- TVS 2300 + fast 52lb injectors... sufficient fuel to support between 8 to 12 lbs of
- RPM surge
- Warranty lifter repair + 1,300 miles = WTF
- Vaporworx Install
- Engine oil cooler install heads up
- Serpentine Belt Installation Help
- Does this look as bad as it sounds?
- Engine oil cooler results
- Coil relocation
- LS3 Swap into a 2008 G8 GT
- Argh... Lean codes.
- Crankshaft Scrapers for Gen IV LS Engines
- New! Improved Racing FSM High-Flow Remote Oil Thermostat
- Hearing weird engine noise rattle or engine surge when the AFM is activated
- New Elite E2 (Larger Design) Catch Can Now Available! Free Shipping!
- P0300 only while in high rpm range
- 416 LS3 Build COMPLETED...videos inside...
- Engine removal?
- it's been a while since I've owned a G8 GT 3 years to be exact, so I have some Q's.
- Do these numbers sound right for a Livernois 2c cam and supporting boltons?
- Another Air Conditioner AC Issues Problems Thread
- parts needed in addition to Pace dod delete kit?
- Another cam thread
- Hiss and Ticking...help?
- GTOG8TA.com Alum-A-Cool Aluminum Radiators Special Install Price $349
- Let's play a game!
- Gas cap keeps loosening
- Swapping LS3 long block into my GT
- Need to replace AC condenser
- Tune out or delete AFM
- Air hiss back of engine?
- hex hood vents
- VMS 1.5 cam???
- Belt/pulley squeek from driver side
- Idle Problem after cam install on hot days
- RCR for the win.
- Fuel Pressure(s) with ZL1 Pump
- Cam gains.
- What type of Aftermarket Fuel Pump?
- Building a Livernois 404 stroker, Complete! Video uploaded
- where does this rubber hose from transmission go?
- LS7 MAF on a Headered GT?
- H Balancer help
- Just installed GXP transcooler
- AFM/DOD tuned off but still on??
- Finally getting car back next Friday.
- *Complete* ZL1 Pump Install
- Which Valve springs kit?
- Need a new thermostat.. How is this one?
- Leaky primary or lifter tick? Help me decide...
- Why does my car hate me?
- New Engine Build Plans
- What's a L76 short block worth?
- Slight oil consumption
- Choice on build
- Advice Needed: Installing New Springs
- Made a really idiotic mistake yesterday - cracked block while torquing head bolts
- Fast idle help
- DOD Delete, Cam, Heads & Road Racing
- Need advice/help from the experts on here! P0300 Cylinder 7 misfire at high RPM's.
- Blower cam on N/A engine
- Valves / Camshaft Need advice
- serpentine and a/c belts
- Melling Oil Pumps
- Optikleen?!
- Which Cam shaft to use
- Balancer Options
- P1133
- DOD questions
- what do you think about this case?
- looking for opinions on a cam for ME
- Front of engine oil leak
- Cam Specs - Thoughts?
- Battery drain!
- Engine Rebuild Opinions
- What is this
- harmonic balancer install
- Checking Harmonic balancer and re tighten ARP
- Help please identify this part
- Anyone interested in a far less expensive and serviceable alternator replacement?
- Custom LSA Swap Engine Harness
- coolant air bleed pipe
- Had a ticking sound and upgrading to a Cam from PatG
- cabin filter install
- More Tear Down & Q's
- Oil Pressure sensor issues
- rear main question
- Looking for previous owner
- Lifter Tick This Morning
- Timing Chain
- ordering new dod delete and cam kit. do I need to replace valve guide seals?
- Ls3 cam swap problems
- AFX110118 - TechAFX G8/ Commodore EVAP Hider Hose Kit Install???
- another cam bearing thread...
- My DOD Delete journey
- I have some questions about head mods and intake.
- Mighty Mouse catch can
- looking for piston options
- It's dead, Jim.
- DoD/ cam swap question
- AFM/DOD Rattle
- not a happy camper
- Roto-Fab New High Flow Intake
- Cleaning heads DIY Q's
- Cam swap labor
- Whats needed for 3.45 differential swap?
- Looking at a GT- I think it's been tuned- How to tell
- Aftermarket intank pumps?
- Need help with cam bearing!!!!
- Power steering cooler
- AC belt fix?
- Ls9 head gasket
- DOD and oil relief valve
- Help identifying a part
- Well, that escalated quickly
- Engine ticking noise- Problem solved!
- CGM motorsports heads?
- L92 oil pump?
- High compression e85 build questions.
- Cooling fan relay and fuse block melted. Need help.
- Is there anything I should do before engine tear down?
- Rear cover/pan seal leak - Dealer wants $2800 to fix
- rpm at 65 mph ?
- Motor hissing sound after cam swap
- High Compression Rebuild with VVT
- electrical connection behind intake manifold disconnected????
- Refilling/bleeding radiator
- Mighty mouse catch can?
- Lsa progress
- 8mpg after cam swap
- 5thgen SS fuel pump work on the g8?
- Burned 8 quarts of oil.....
- Severely Underpowered after DOD delete
- Genuine GM Rear Main Seal Housing (Complete Set) Part Number?
- Dyno of 416ci Stroker 499whp /433wtq
- Radiator removal/reinstall DIY - also radiator design improved?
- shifting problem
- Yet another engine ticking question
- PLEASE HELP! harmonic balancer
- Need Advice on H/C and DOD delete build
- Upgraded a Norris Catch Can
- throttle body low power mode
- Help sourcing missing throttle body screw
- Engine is going through oil... Turn of DOD / Tune?
- DOD cam: Your experience, and what you would do different if you could do it again
- Crank pulley issues...
- Anyone running a 427ci with a tvs supercharger?
- Cam and lifter failure; rebuild
- Spark plugs
- Trick flow cams
- BEST PLACE TO BUY 418CID SHORTBLOCKi will
- S480 too much turbo on a stock trans?
- Does the GT need a power steering pulley puller?
- Horn and steering controls not working
- CNC Ported LS3 heads
- P0420 with Cortex 91 Rotofab, magnaflow cats, new O2s, extenders
- Oil leak near front driver side wheel
- L76 into camaro
- TSP Cam
- Possible Leak Of...Something
- Redx
- Help what all could causea CEL P0446
- VCM OTR Intakes now shipping from gtog8ta.com
- VALLEY COVER question, DOD delete
- Coolant leak in my G8
- RCR Cam
- Misfire at low Tps???
- ARH headers...where to install bung?
- Another lean bank 2 code *(P074)
- RCR cams, but with only milled heads and ls3 valves?
- LS7 Lifters
- Surging Idle, and Erratic Coolant Temperature
- Under drive pulley installed with ease thanks to my sweet home made tool.
- Questions for you LSA guys.
- Recommended replacement cats for ARH headers
- Very brief clunk/knock on startup
- Springs/valves on DOD delete help.
- Any advice on sealing slip fit?
- It Sprayed on my windshield as if the car in front of me...
- Upper rad mounts - will caprice mounts work?
- Aftermarket cam with stock intake question
- Billet valve cover question...
- Cold Case / GTOG8TA.com Aluminum Radiator
- Start up high rev
- Carbon buildup on one cylinder
- Contact Dealer Red X
- Intermittent misfire problems
- Lifter tick on start. Oil brand/weight possible fault??
- Question about an oil pump
- Cam install with High miles?
- Forged internals?
- gate power grip clamps, hose clamps in general
- cam suggestions
- Upgrades and upgrades noob questions
- P0521 Low engine oil presure
- Couple of questions cam related and suspension
- Cold Case RAD
- Radiator drain plug
- Replaced gas cap, evap solenoid and still P0446 cel code
- correct downstream oxygen sensors?
- Cutting off extra mounts on the oil pan
- LSA How To write up (document enclosed)
- LS7 lifters, should I be worried?
- Reliablity questions with modifications
- My RCR Cam Install 219/223 .612/.615 112+1
- LS Oil Pump Pickup Tube Brace / Girdle
- What's the difference between the LSA and L92 heads?
- Engine barely idling and white smoke
- I was told I will need a converter
- Oil leak experiences.
- Lifter noise and questions
- Typical to get two engine lights after oil service light?
- Help me trouble shoot a noise
- Mods to prepare for LSA when doing DOD delete
- Realistic gains from headers/ exhaust / ramjet/ underdrive pulley and tune
- Radiator cap broken, hose popped off again.
- Best place to buy Delphi updated AFM lifters
- Advice needed: Flickering lights
- Aeromotive stealth system from Camaros fit our cars?
- Latest consensus on fuel pump upgrade
- accelerator pedal position sensor
- Explain the feel of bad motor mounts?
- ECU removal and replacement 2009.5
- Slow Fuel filling
- Replacement plug
- Lower radiator fitting options?
- GXP upper radiator hose
- Rocker torque sequence
- stretchy belt or updated idler bracket for A/C
- Possible lifter failure?
- Improved Racing Billet Crank Scraper and Windage Trays
- ppv dual idler a/c bracket on a GXP??
- Another power loss and throttle response thread
- Car starts for 5 seconds and turns off
- No Need to Upgrade to an SS with THIS!
- Don't Let your Car Manage Your Fuel!
- Stuck in the hole
- loud clatter!!!!
- The quest for 11's with intake, tune, headers, suspension and DR possible?
- Possible damaged A/C compressor
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.