Got a few questions for the masses:
Recently purchased an 09 GT with 9500 miles. Car runs great, sounds great, but was 'dyno tuned' prior to my purchase. I was curious today so I threw my BlueDriver OBD reader on it and it is pulling the 'P0171 System Too Lean Bank 1' with short drives, not going over 25 MPH.
Modifications are as follows:
- Kooks LTH
- SLP Loudmouth Exhaust
- Rotofab Intake
I'm fairly mechanically inclined, just need some direction. Does it make sense that the reader is pulling the P0171 but not triggering the CEL? Is this something that could have been tuned to not display?
I feel like I hear air, but I did some poking around and couldn't really find anything. Used a long oil funnel to help listen. Seemed to get loudest over the center of the intake manifold where my PCV tube is routed or the back of the motor. Checked out some of the hard vacuum lines and didn't see any cracks. The areas surrounding each injector did look dark, plausible that I need new O-rings due to the low mileage but didn't hear air coming from this area.
Exhaust manifold leaks could cause this from things I've read; is there a good/easy way to check for this? With how little miles has been put on since installation, I don't SEE anything wrong, but doesn't mean there isn't a leak.
Checked my fuel trims on the way to work this morning. Drive was 10 minutes, was at operating temperature by arrival, and I gave it a few 3,000 RPM accelerations. The P0171 code shows under the ECM codes, but will not read under the CEL codes or illuminate the CEL. The codes haven't been cleared for the last ~400 miles.
Bank 1 STFT (HIGH): 10.2%
Bank 1 STFT (LOW): -7.8%
Bank 2 STFT (HIGH): 10.9%
Bank 2 STFT (LOW): -8.5%
Bank 1 LTFT (HIGH): 6.3%
Bank 1 LTFT (LOW): -0.8%
Bank 2 LTFT (HIGH): 4.7%
Bank 2 LTFT (LOW): -0.8%
Google Drive link to the report: https://drive.google.com/file/d/0B7f...ew?usp=sharing
Going to do a little more reading while I wait for some/any input.