A/C belt fix install
I'm planning on buying the A/C pulley fix that CrazyPaul is selling, but before I do, I'd like to know what I'm getting myself into.
The main thing is whether or not this is a driveway job or shop job. What I mean by that is can It be done on the ground and can the compressor bracket be swapped out without disconnecting any of the lines?
If it can be done at home, are there any recommendations on how to procede?
Thanks.
Current:
2016 Chevy SS - "Some Like it Hot" Red Metallic
Previous:
2009 G8 GT - Sport Red, Sport Package, Vararam CAI, Borla Exhaust
No refrigerant lines need to be unhooked. You can do it in your garage or driveway. I found a DIY on the other board, could not find one on this one. It is not too hard:
http://www.g8board.com/forums/showthread.php?t=68272
Rotohack 102 intake - 102 MAF - TPIS 102 TB - TVS1900 ported & plated w 8 rib 2.5" front + OD rear
PnP Interchiller - RCR ported heads - RCR Lunati 219/231 113+1 - Forged Bottom End
ARH 2" LT headers - Solo 3" CB - MT DRs + M&H FRs on Weld RT-S
CTS-V fuel w Vaporworx - FAST 85s - Alkycontrol meth M15 + M10 - RCR tune
9.75@139.2 ? rwhp ? rwtq
Excellent. Thank you very much.
Current:
2016 Chevy SS - "Some Like it Hot" Red Metallic
Previous:
2009 G8 GT - Sport Red, Sport Package, Vararam CAI, Borla Exhaust
Posting Permissions
Reply With Quote